Bachmann Dynamis Guide de l'utilisateur télécharger pdf (Page 4)

Dynamis ProBox

If the Pro Box cannot determine which locomotive roster to use the user will be asked on the

Handset which to use:

OK TO RESET INT

LOCOMOTIVE LIST?

OK the locomotive roster of the handset will be erased and the one

on the Pro Box will be used and automatically synchronized with

the handset.

USE THE ROSTER THAT EXISTS ON THE PRO BOX

AND TRANSFER IT TO THIS HANDSET

Cancel the locomotive roster of the Pro Box and all other handsets in the

network will be erased and the locomotive roster of this handset

will be synchronized to all other units in the network.

USE THE ROSTER FROM THIS HANDSET AND TRANSFER

TO THE PRO BOX AND ALL OTHER HANDSETS

Do not press cancel on more than one Handset at the same time

There are cases where you can lose synchronization between your handset and your Pro Box:

- Disconnection during transmission

- Editing the locomotive roster without connection to Pro Box (offline usage)

- Handset disconnected whilst editing the locomotive roster on another Handset

- Connecting the Handset to a different Command Station or Pro Box

- Switching the unit off during data transmission

Merging of locomotive rosters is not possible although it is possible to copy a roster from one

Pro Box to another via a Handset.

If you switch off a Handset or put it out of range from the Pro Box, the Pro Box will remove the

Handset after some time. If the Handset gets back in range it will automatically be connected

back to the network, but it may have to be resynchronised.

3.3 Programming track operation

When used with a Pro Box, Dynamis can both change decoder CVs on the MainTrack and on a

‘Service’ or ‘Programming’ track, using a second connector.

Dynamis ProBox

A Service Track allows the values stored in a locomotive decoder to be determined (‘read’) and

all decoder CVs may have values set (‘written’) by this method. The Dynamis Handset allows a

choice of several methods to write to the CV: those appropriate to the decoder in use should

be determined from decoder instructions and the methods selected following the instructions in

the Dynamis User Guide. Do not attempt to read from more than one decoder at the same time.

During Service Track operation the power is cut from the Main Track, and the output current

threshold is reduced.

During a CV write operation the acknowledgement pulse from the decoder is evaluated and an

error message will be displayed if an error occurs in the write operation. Dynamis does not

abort the write operation which means that decoders without an acknowledge capability can still

be written. An error message will be displayed if faulty a read operation occurs.

The ‘Address Read’ item on the Handset menu is used to determine the address (long or short)

of the locomotive decoder currently on the Service Track . An error message will be displayed

in the event of a faulty read operation. If the Pro Box can successfully read the address from

the decoder, the address of the currently selected locomotive in the roster is changed to the

newly read address.

3.4 Programming methods used on the Dynamis Handset

Write address on Maintrack

Changes a short address to another short address on the Maintrack (If this

supported by the decoder - check with the decoder instructions). The initial

address of the decoder being changed from must be known.

Write address on Servicetrack

Use this option to set an address to a decoder

Overwrites a short or long address on the decoder. Dynamis handles all CV

changes needed to set a long address. The initial address of the decoder

being changed can be unknown.

Read address on Servicetrack

Reads a short or long address from the decoder. Dynamis reads all CV

needed to identify a long address

Program on Servicetrack

Read and write decoder CV values using the Service Track

Program on Maintrack

Write decoder CV values on the Maintrack to the decoder under control

3.5 Resetting the system

1. Resetting the handset

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire

Bachmann Dynamis Guide de l'utilisateur Page 4

Commentaires sur ces manuels